Day 1 of Making

Bought 10 A1 pieces of grey board today… hopefully this should be enough to make the whole thing!

Here are my “to scale” plans:

face view from inside the booth (if you were sitting on the chair)

view from outside the booth

side view

end of day 1

This is where I had trouble with my measurements. I didn’t make the top long enough. It was 15 cm, now its 40… hopefully this will work now. But this is the annoying thing about not being able to actually putting these pieces together. Unfortunately I can’t put it all together until im in the studio, otherwise I wont be able to transport it to college… also I can’t hammer nails, or hooks or shelves into these walls. Fingers crossed I can get this all done in time.

Monday morning, assemble the whole thing. Then that will leave tues and wed to finish it off, practice on people… and do evaluation. LOTS OF WORK!

Tomorrow- plan is to get the graphics done (instructions, and anything else that will go on it, and maybe make a start on evaluation and paperwork)